How To Drain Whirlpool Dishwasher

Whirlpool dishwashers are a common and popular choice for many homeowners. This video will show you how to properly drain your dishwasher so that you can avoid any unwanted spills or water damage.

How To Drain Whirlpool Dishwasher

There are a few ways to drain a whirlpool dishwasher. One is to use the dishwasher’s manual drainage method. This is done by opening the dishwasher and locating the drainage hose. The drainage hose is attached to the pump and is located in the lower right-hand corner of the dishwasher. The other end of the drainage hose should be placed in a sink or bucket that is lower than the dishwasher. The water will flow out of the dishwasher and

You will need a bucket, a screwdriver, and a wrench.

  • Open the dishwasher door and locate the drainage spout
  • Place a large colander or pot beneath the spout to catch the water
  • Open the dishwasher’s drain valve by rotating it counterclockwise allow the

– Make sure dishwasher is turned off – Unplug dishwasher or turn off breaker to dishwasher – Locate the drain hose on the dishwasher and disconnect it from the dishwasher – Place a bucket underneath the hose to catch the water – Open the dishwasher door and locate the pump filter on the bottom of the dishwasher – Remove the pump filter and dump out any water that is in it – Replace the pump filter and close the dishwasher door


Frequently Asked Questions

What Causes A Whirlpool Dishwasher Not To Drain?

There are a few things that can cause a dishwasher not to drain properly. One possible reason is a clogged dishwasher drain. Another reason might be a kink in the dishwasher drain hose. If the dishwasher is not draining properly, it is possible that the water is not being pumped out fast enough and is backing up into the dishwasher.

How Do You Unclog A Drain On A Whirlpool Dishwasher?

You can unclog a drain on a Whirlpool dishwasher by using a plunger. Put the plunger over the drain, and plunge up and down.

How Do I Test A Whirlpool Dishwasher Drain Valve?

To test a dishwasher drain valve, remove the dishwasher hose from the valve and place it in a bucket. Turn on the dishwasher and watch to see if the water drains out of the hose into the bucket.


In The End

There are a few ways to properly drain a whirlpool dishwasher. One way is to use the dishwasher’s dedicated drain hose, which should be connected to the nearest sink or drainage area. Another way is to use the dishwasher’s built-in pump, which can pump water out through a garden hose.

Leave a Comment

Your email address will not be published.