How To Reset Kenmore Washer

There are a few ways that you can reset a Kenmore washer. One way is to unplug the washer for about 30 seconds and then plug it back in. You can also press and hold the power button on the washer for about five seconds to reset it. Another way to reset the washer is to open the door and hold down the cancel button for about five seconds.

How To Reset Kenmore Washer

There is no one definitive way to reset a Kenmore washer. However, many users have found success by unplugging the machine, waiting a few minutes, and then plugging it back in. Others have had success by pressing and holding the power button on the machine for a few seconds. Still others have had success by pressing the cancel button and then the start button. If these methods do not work, it may be necessary to refer to the washer’s manual or contact the

Required tools: Phillips screwdriver, wrench, bucket. Material needed: Water, bucket of ice.

  • Open the washer lid and locate the two screws at the top of the washer that hold the front panel in place
  • Locate the water supply valve and turn it off
  • Unplug the washer from the outlet

below – Inspect the hoses for any leaks. If you find any, tighten the clamps or replace the hose. – Check the water inlet valve for any leaks. If you find any, tighten the screws or replace the valve. – Unplug the washer and close the water supply valves. – Remove the two screws that hold the top of the washer in place and remove the top. – Disconnect the wires from the lid switch and unscrew it


Frequently Asked Questions

How Do I Reset My Kenmore Front Loading Washer?

To reset a Kenmore front loading washer, unplug the appliance and open the door. Then, press and hold the cancel and start buttons simultaneously for three seconds. Finally, plug the appliance back in and close the door.

How Do I Reset My Kenmore Elite Top Load Washer?

To reset your Kenmore Elite top load washer, unplug the machine and remove the water supply hoses. Next, locate the wire harness at the back of the machine and disconnect it. Now, turn the machine upside down and shake out any excess water. Finally, reconnect the wire harness and reattach the water supply hoses.

How Do I Reset My Kenmore Front Load Washer?

There is no one-size-fits-all answer to this question, as the process for resetting a Kenmore front load washer may vary depending on the specific model. However, some general steps that may be useful for resetting a Kenmore front load washer include unplugging the machine, waiting for a few minutes, and then plugging it back in. Once the machine is plugged back in, users may need to wait a few minutes before attempting to use it again.


To Review

Kenmore washers are designed to be reset through a process of unplugging the machine, waiting 30 seconds, and then plugging it back in. Once the machine is plugged back in, the user should press and hold the start/pause button for three seconds in order to restart the washing cycle.

Leave a Comment